The menu is where one can deal with the tracks, busses and control masters.
- Add Track, Bus or VCA…
- Shows the window, where one can add one or more tracks, busses or control masters to the session and define its parameters
- Duplicate Tracks/Busses…
- Shows the window, allowing to duplicate the selected track(s) and optionnaly, its playlist
- Toggle Record Enable
- Sets the Record Enable mode On on the selected track(s). These tracks will record audio/midi next time the global record is active and playback is started.
- Toggle Solo
- Sets the solo On on the selected tracks, so only these tracks will play
- Toggle Mute
- Mutes the selected tracks, they wont play until unmuted
- Insert Time
- Shows the window, allowing to insert a blank time in the selected tracks' playlist
- Remove Time
- Same as above, but to remove time
- Move Selected Tracks Up
- Changes the position of the selected tracks one track up towards the top. In the mixer, the tracks will be moved to the left.
- Move Selected Tracks Down
- Same as above, towards the bottom
- Height
- Fit Selection (Vertical)
- Will fit the selected track(s) in the window. If too many tracks are selected, they'll be reduced to their minimum height.
- Largest
- Sets the selected tracks height to a very high value, hence making the tracks wide on screen
- Larger
- Same as above, but a little less high
- Large
- Same as above, but again less high
- Normal
- Sets the height of the track to its default value which is a trade-off between readability and number of tracks displayed
- Small
- Reduces the size of the tracks to a low value, increasing the number of on screen tracks
- Toggle Active
- Toggles the active state of a track. An inactive track will be grayed and wont play any sound. That can be seen in the colomn of the Tracks and Busses List
- Remove
- Deletes this track and its playlist (no file is harmed in the process, and the regions from the playlist stay in the Editor for later use)