50 lines
1.9 KiB
HTML
50 lines
1.9 KiB
HTML
|
---
|
||
|
|
layout: default
|
||
|
|
title: Working With Extenders
|
||
|
|
menu_title: Working With Extenders
|
||
|
|
---
|
||
|
|
|
||
|
|
<p>
|
||
|
|
Extenders will require a custom file as there are no combinations listed
|
||
|
|
at this time. The best way is to start with the mc.device file and copy it
|
||
|
|
to a new name such as xt+mc.device and then edit that file. It is best to
|
||
|
|
name the file with the order the devices are expected to be used in as
|
||
|
|
the position of the master device is specified in this file.
|
||
|
|
</p>
|
||
|
|
<p>
|
||
|
|
The two lines of interest are:
|
||
|
|
<p>
|
||
|
|
<pre>
|
||
|
|
<Extenders value="0"/>
|
||
|
|
<MasterPosition value="0"/>
|
||
|
|
</pre>
|
||
|
|
<p>
|
||
|
|
Add these two lines if they are not present. The <code>Extenders</code>
|
||
|
|
value is the number of extenders used and should not include the master in
|
||
|
|
that number.
|
||
|
|
</p>
|
||
|
|
<p>
|
||
|
|
When an <code>Extenders</code> value of greater than 0 is used, extra midi
|
||
|
|
ports will appear for the extenders to be connected to. The MIDI ports
|
||
|
|
for the controllers will be named <code>mackie control #1</code>,
|
||
|
|
<code>mackie control #2</code> and up. The numbers will go from left to
|
||
|
|
right. That is, from lowest number channel to highest.
|
||
|
|
</p>
|
||
|
|
<p>
|
||
|
|
The <code>MasterPosition</code> value is the port number the master unit
|
||
|
|
(with the master fader) is connected to. So if there are three surfaces,
|
||
|
|
<code><MasterPosition value="1"/></code> will expect the master on
|
||
|
|
the left, <code><MasterPosition value="2"/></code> would be master
|
||
|
|
in the middle and <code><MasterPosition value="3"/></code> would be
|
||
|
|
master on the right. So the position matches the port name.
|
||
|
|
</p>
|
||
|
|
<p class="note">
|
||
|
|
The default value of <code><MasterPosition value="0"/></code> has
|
||
|
|
the same effect as <code><MasterPosition value="1"/></code>.
|
||
|
|
</p>
|
||
|
|
<p>
|
||
|
|
If the <code>MasterPosition</code> value does not properly match the
|
||
|
|
physcal position and MIDI port, the master fader and global controls will
|
||
|
|
not work. The master unit will act like an extender.
|
||
|
|
</p>
|