manual/include/track-automation.html

84 lines
3.2 KiB
HTML
Raw Normal View History

2017-02-21 15:55:11 -05:00
<figure class=right>
<img src="/images/automation-menu1.png">
<figcaption class=center>The automation menu.</figcaption>
</figure>
<p>
To automate a parameter on a given track, click on the track's <kbd
class=menu>A</kbd> button and select a parameter to control from the menu
that appears. Once a parameter has been selected, an automation lane for that
parameter will appear beneath the track. The lane thus shown will be empty;
from here an automation curve must be defined.
</p>
<p class=note>
If the height of the automation lane is too small to see all of its controls,
the height can be increased by <kbd class=mouse>Left</kbd> clicking on the
bottom border of the lane and dragging it.
</p>
<p>
There are three ways to define an automation curve:
</p>
<ul>
<li>Record it using <kbd class=menu>Write</kbd> mode</li>
<li>Record it using <kbd class=menu>Touch</kbd> mode</li>
<li>Draw it using the mouse</li>
</ul>
<h2>Recording an Automation Curve Using Write Mode</h2>
<p>
To create an automation curve using <kbd class=menu>Write</kbd> mode, first
set the lane's mode selector to <kbd class=menu>Write</kbd>, then set the
playhead to the position where the automation curve should start, then set
the transport to play. While the playhead is moving, Ardour will continuously
record any changes made with the lane's fader. Even if no changes are made to
the fader, they will overwrite anything that existed in the lane where the
playhead is moving. When the desired automation curve has been recorded, stop
the transport.
</p>
<p class=note>
After the transport is stopped, the lane's mode selector will automatically
switch to <kbd class=menu>Touch</kbd> mode&mdash;it is generally a bad idea
to leave an automation lane in <kbd class=menu>Write</kbd> mode, as it is a
destructive operation that makes it easy to inadvertently overwrite existing
automation curves.
</p>
<h2>Recording an Automation Curve Using Touch Mode</h2>
<p>
Creating an automation curve using <kbd class=menu>Touch</kbd> mode is
similar to the method employed in creating one using <kbd
class=menu>Write</kbd> mode; the only difference is that changes are written
to the automation curve <em>only</em> when the lane's fader is moved&mdash;at
all other times, whatever was in the automation curve will remain as it was.
</p>
<p class=note>
<kbd class=menu>Touch</kbd> mode is useful when only small parts of the
automation curve need touching up versus <kbd class=menu>Write</kbd> mode,
which is usually used to create the automation curve in the first place.
</p>
<h2>Drawing an Automation Curve Using the Mouse</h2>
<p>
In <dfn>Draw</dfn> mode, <dfn>control points</dfn> can be entered in the
automation lane by <kbd class=mouse>Left</kbd>-clicking in the lane at a
point where there is no existing control point.
</p>
<p>
Once added, a control point can be <kbd class=mouse>Left</kbd>-clicked and
dragged to a desired location. Hovering over a control point will show its
current level in dB. To remove a control point, <kbd
class=mouse>Left</kbd>-click it and press <kbd>Delete</kbd>, or <kbd
class=mod3n></kbd><kbd class=mouse>Right</kbd>-click on it.
</p>